Plunge routers typically have a bit of heft to them, and this can make them a bit easier to control. The other thing we’re not keen on is how unsubstantial it is. If you don’t see all the bits you’ll need here, then it’s probably not the router for you. The official bit set of seven bits sells for £29, and there’s also a common ten-piece set that sells under a range of off-brand names that expands on it slightly and contains:Īs far as we’ve been able to tell, these are the only bits available with a 3 mm shaft. The result is that there are far fewer bits available for Dremel routers. The Dremel router needs bits with a 3 mm shaft, while the standard is 6 mm. On that very basic level, it's worked, but we do have a couple of fairly serious reservations about this tool.īy far and away the biggest limitation of the Dremel router is the chuck/collet size – it’s far smaller than those on regular routers. Bits have been spun, wood has been carved, and objects have been created. We’ve been using this tool for a few months now, and have put it through the test on a few builds, including on the ‘word clock’ from issue 20. If you’re of a more automatic bent, some people have created CNC jigs for rotary tools – there are some quite impressive looking builds like this, but we’re yet to get one in our test lab. If you’d prefer a different routing setup, Dremel also sells a table router, a line and circle cutter, and a ‘multipurpose cutter’. There are all the features you’d expect of a plunge router: two solid handles enable you to push the bit down into wood, an end-stop lets you limit the depth, and a fence to enable you to cut a groove parallel to an edge. It contains all the basic bits you need for routing – in our test setup, we had a Dremel 3000 with a chuck (though a collet will work equally well). You should be able to unscrew the end of your rotary tool, and this screws into the router body to make your router. It comes as a set of parts, but it’s easy to slot together. It should work with most official Dremels, and many rotary tools from other brands. This isn’t a product in its own right, but an adaptor for Dremel rotary tools to convert them into plunge routers. Using this edge, you can carve out grooves, or hollow out whole areas in wood and some plastics. Plunge routers, as the name suggests, allow you to plunge the bit downwards and start a cut in the middle of a piece of wood (other routers require you to come in from the side). There are quite a few different types of router, but they all do the same basic job – spin a bit that’s designed to cut sideways (rather than downwards, as drills do).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |